|
Easy
to follow instructions:
- Connect the clear end of the Flush King to the sewer outlet
- Connect
the sewer hose to the other end of the valve
- Connect
the water line to the shut-off valve at the top of the Flush
King
- Open
the black tank valve and the Flush King Valve and drain as normal
- Close
the Flush King valve and turn on the water and check the amount
of time it takes to refill the black tank to avoid over filling!
(This can also be done by checking the monitor or looking into
the holding tank from the toilet.)
- Open
the Flush King Valve and drain again. This process may be repeated
as many times as necessary to obtain a clean tank
- Close
the black holding tank valve and repeat the cleaning process
by opening the gray valve
- The
last rinse has cleaned the sewer hose
- Remove
valve after cleaning
(Note:
It takes approximately 4 minutes to fill a 50- gallon tank.)
|

- Warning!
Do not leave the Flush King
Valve and the holding tank valve closed when turning on
the water! Too much water pressure will damage the Flush
King.
(Broken
valves can be repaired. Please call for repair prices.)
|
|